Traction ruler cutting machine
Auxiliary equipment on extruder for car wiper sheath
Application: Count the meter to cut off
The setting of the cutting machine ’s knife mold altitude
1.Clean the sundries on the rubber board of the work table.
2.After the machine is running, loosen the setting handwheel, Adjust the "pressure system" to zero.
3.Turn the setting switch right to the direction of the cutter setting. The cutting board of the cutting machine starts slowly downward and sticks to the cutter die and stops automatically
4.Push the handwheel down to the bottom and tighten it.
5.Press the brake switch again, the cutting platen immediately rises to the highest azimuth, at the moment the cutter die set is finished