

Silicone cable production line
Key words:
Silicone cable production line
Classification:
Silicone extruder

Business Hotline:
Silicone cable production line
Service characteristics of silicon rubber high temperature resistant cable
1. the maximum operating temperature of the cable conductor is 180 centigrade.
2. the maximum temperature of the cable conductor shall not exceed 350 DEG C when the short circuit lasts (for 5 seconds maximum).
3. the allowable bending radius of cables: cables without armour or shielding structure shall be no less than 6 times of the outer diameter of the cable, and cables with armored or shielding structure shall be no less than 12 times of the outer diameter of the cable.
4. cable laying temperature: greater than or equal to -20 degrees, lower than the temperature, laying the cable should be preheated.
This machine is suitable for silica gel Extrusion insulation or sheath wire production, convenient operation, high reliability.
Model |
XJ-45 |
XJ-65 |
XJ-80 |
XJ-110 |
Screw diameter (mm) |
45 |
65 |
80 |
110 |
Draw ratio |
12:1 |
12:1 |
12:1 |
12:1 |
Motor Power (kw) |
7.5 |
11 |
15 |
30 |
Screw speed(r/min) |
10-70 |
10-70 |
10-70 |
10-70 |
Output (kg/h) |
20-30 |
40-60 |
120-150 |
200-280 |
Silicone extruder size:
Silicone cable production line applies to extruding insulation or sheath for silicone cable.
Silicone cable insulating line not like other type copper cable which use water cooling, it use heating to produce cable (vulcanization tunnel).
Working flow introduction:
Pay off stand----.Silicone extruder----high temperature oven-----Curing box-----Traction machine------Rewinding machine
Put the wire core through the mold core and connect with the lead
pass the spark machine and pass through the powder box,
wind it on the traction wheel for 3 to 4 timesand then fix the lead wire on the take-up reel
1.Pay off stand
Electrical cable plate in red box can design according the customer requirement
Back side equipment with motor control the plate rewinding
Adjust the cable tension with three rollers
2.Silicone extruder
The L:D of the silicone extruder is shorter and the configuration is lower.
Silicone extruder machine working as the indoor temperature
The production method of silicone wire is to combine the rubber and the inner core of the wire with a cross head.
3.T type( cross head)machine head
The cable and the rubber in the barrel are rounded in the T-shaped head
Extruding silicone cable wrapped with silicone
4.high temperature oven
Vulcanizing equipment
The heating temperature can reach 300-400℃, so that the surface of silica gel products can be quickly shaped at high temperatures, and the transmission of silica gel products and the vulcanization and setting of the surface of the products can be realized.
5.Curing box
Vulcanizing equipment
The heating temperature can reach 180-200℃
Complete the secondary vulcanization effect
Contact: Ms. Jiang 18631970441
Ms. Wang 15530958789 junyan-j@shuangdajx.cn
Related products
Feedback
Shuangda

Hebei Shuangda Rubber Machinery Co., Ltd.
Tel:400-0319-386
Landline:+86-319-6017632
Email:shuangdaxiangsu@126.com
Official website:www.shuangdasuji.com
Addr:Liyuantun Industrial Zone, Weixian County, Xingtai City, Hebei Province
Copyright © 2022 Hebei Shuangda Rubber Machinery Co., Ltd.