Structure characteristics and installation of vulcanization box
Time：
2021-09-15
1.This unit is consist of conveying device, vulcanizing box, heat generator, box door, rack, electrical control box.
2.The transmission motor is equipped with frequency converter, which can adjust the conveying speed at any time.
3.The two ends of the conveying roller are equipped with a deviation adjusting device, which can adjust the belt to run in the middle, and one end of the device is provided with a tightening roller, so that the belt is in a tight state
4.Each section of the equipment is divided into two zones to control temperature, and two thermocouples are installed at the back of the equipment to control the temperature values of each district.
5.The electric control box is installed in the bottom frame of the vulcanizing box, with temperature controller, power switch, heating switch and frequency converter switch.
6.The speed control box is equipped with a speed control panel and a potential governor, which is easy to operate.
7.Equipment installation environment temperature of 0-40 degrees (non freezing, condensation), relative humidity PH < 90% (not condensation), altitude below 1000 meters, no dust around, corrosive gas, flammable gas, and avoid violent vibration.
Related news
Shuangda
Hebei Shuangda Rubber Machinery Co., Ltd.
Tel：400-0319-386
Landline：+86-319-6017632
Email：shuangdaxiangsu@126.com
Official website：www.shuangdasuji.com
Addr：Liyuantun Industrial Zone, Weixian County, Xingtai City, Hebei Province
Copyright © 2022 Hebei Shuangda Rubber Machinery Co., Ltd.