Structure characteristics and installation of vulcanization box

  • Categories:Industry news
  • Author:Hebei ShuangDa
  • Origin:
  • Time of issue:2018-11-19 00:00
  • Views:

(Summary description)

Structure characteristics and installation of vulcanization box

(Summary description)

  • Categories:Industry news
  • Author:Hebei ShuangDa
  • Origin:
  • Time of issue:2018-11-19 00:00
  • Views:
Information

1.This unit is consist of conveying device, vulcanizing box, heat generator, box door, rack, electrical control box.

2.The transmission motor is equipped with frequency converter, which can adjust the conveying speed at any time.

3.The two ends of the conveying roller are equipped with a deviation adjusting device, which can adjust the belt to run in the middle, and one end of the device is provided with a tightening roller, so that the belt is in a tight state

4.Each section of the equipment is divided into two zones to control temperature, and two thermocouples are installed at the back of the equipment to control the temperature values of each district.

5.The electric control box is installed in the bottom frame of the vulcanizing box, with temperature controller, power switch, heating switch and frequency converter switch.

6.The speed control box is equipped with a speed control panel and a potential governor, which is easy to operate.

7.Equipment installation environment temperature of 0-40 degrees (non freezing, condensation), relative humidity PH < 90% (not condensation), altitude below 1000 meters, no dust around, corrosive gas, flammable gas, and avoid violent vibration.

Hebei Shuangda Rubber Machinery Co., Ltd. Address: Liyuantun Industrial Zone, Wei County, Xingtai, Hebei Rubber extrusion equipment series

冀ICP备12010512号-1        Powerded by 300.cn